Condor

Hello,

I am suffering some problems with Condor recently. When I play Condor on my Quest2 via the Steam/Revive method, Condor shuts down abrubtly after approximatly 10 to 20 minutes. There is no fault message of what so ever. I have to “re-inject” Condor again to start a new flight.
During flight I have perfect graphics. MSAA is disabled in the Condor setup.
Anyone known with this issue?

I am using Revive 1.8.0, and tried other versions of Revive (those would not inject Condor on my pc).
I am using the original Oculus link-cable.
Pc specs: Ryzen 5 2600 with 3,4 Ghz, 16 GB DDR, Graphic card GTX 1660super.

Thanks, Anthony.

I had a similar issue, but not with Condor, where the Quest2 would suddenly lose the link connection. That was caused by my PC USB socket not being able to supply sufficient power. A powered USB hub sorted that out nicely. I have not had the problems you describe since. Could this be the issue?

Chris

This could very good be the issue. Had to order a powered USB-hub. So I have to be patient to try if this will do the trick for me as well.