Hi all,
Firstly, thank you for the Pegase model, this is an A model presumably?
I was able to interchange panel data and cockpit textures. The skins are slightly
different on this Pegase though, so I could not directly use the skins from the other two
ASW's.
I think the texture map was not completed on this model?
There are some parts scattered under the wing and near the port fuselage half,
these parts have not been scaled or mapped properly ....
A missing texture at wing / aileron junction....
but only on Starboard wing.
Airbrake caps and boxes rendering different colours on port and
starboard, with some apparent overlapping of colours, this may
be clearer once the parts are mapped, but it's very confusing
to the painter at this time.
Also, the Tost Releases are rendering different colours and I
cannot find the parts on the texture map.
The Rudder control rod exit boxes don't appear to be mapped,
but they are rendering grey colour at present.
Back of wing here is rendering partially....
Centrair Pegase 101
Moderators: Uros, OXO, BenFest
Centrair Pegase 101
You do not have the required permissions to view the files attached to this post.
Last edited by congo on Thu Oct 29, 2020 7:57 am, edited 4 times in total.
Re: Centrair Pegase 101
Ok, I figured it out. There is an anomaly with the linking of the port airbrake caps and port brake box.
Lower Ailerons are marked here as well.
Here it is rendered in Condor..... The upper and lower surfaces of the airbrake caps are rendering the same colour.
(Not shown here)
Lower Ailerons are marked here as well.
Here it is rendered in Condor..... The upper and lower surfaces of the airbrake caps are rendering the same colour.
(Not shown here)
You do not have the required permissions to view the files attached to this post.
Re: Centrair Pegase 101
Hello,
Are you going to suggest a correction? I would like to modelize the pegase of my club but the result is not perfect
Are you going to suggest a correction? I would like to modelize the pegase of my club but the result is not perfect
You do not have the required permissions to view the files attached to this post.