Centrair Pegase 101

Moderators: Uros, OXO, BenFest

Post Reply
User avatar
congo
Posts: 291
Joined: Wed Aug 24, 2011 10:21 am
Location: Queensland, Australia

Centrair Pegase 101

Post by congo » Thu Oct 29, 2020 2:42 am

Hi all,

Firstly, thank you for the Pegase model, this is an A model presumably?

I was able to interchange panel data and cockpit textures. The skins are slightly
different on this Pegase though, so I could not directly use the skins from the other two
ASW's.

I think the texture map was not completed on this model?

There are some parts scattered under the wing and near the port fuselage half,
these parts have not been scaled or mapped properly ....
Pegase-Parts.jpg
A missing texture at wing / aileron junction....
but only on Starboard wing.
pp1a.jpg

Airbrake caps and boxes rendering different colours on port and
starboard, with some apparent overlapping of colours, this may
be clearer once the parts are mapped, but it's very confusing
to the painter at this time.

Also, the Tost Releases are rendering different colours and I
cannot find the parts on the texture map.

The Rudder control rod exit boxes don't appear to be mapped,
but they are rendering grey colour at present.

Back of wing here is rendering partially....
pp345.jpg
You do not have the required permissions to view the files attached to this post.
Last edited by congo on Thu Oct 29, 2020 7:57 am, edited 4 times in total.
Image

User avatar
congo
Posts: 291
Joined: Wed Aug 24, 2011 10:21 am
Location: Queensland, Australia

Re: Centrair Pegase 101

Post by congo » Thu Oct 29, 2020 2:58 am

Ok, I figured it out. There is an anomaly with the linking of the port airbrake caps and port brake box.

Lower Ailerons are marked here as well.
pp4.jpg

Here it is rendered in Condor.....
Shot217.jpg
The upper and lower surfaces of the airbrake caps are rendering the same colour.
(Not shown here)
Shot222a.jpg
You do not have the required permissions to view the files attached to this post.
Image

kingair96
Posts: 3
Joined: Tue Jan 31, 2017 4:37 pm

Re: Centrair Pegase 101

Post by kingair96 » Fri Nov 13, 2020 9:41 am

Hello,
Are you going to suggest a correction? I would like to modelize the pegase of my club but the result is not perfect :(
You do not have the required permissions to view the files attached to this post.

Post Reply