ObjectEditor - Load Failed

Moderators: Uros, OXO

Post Reply
tarn
Posts: 29
Joined: Mon Dec 23, 2013 10:21 pm

ObjectEditor - Load Failed

Post by tarn » Thu Mar 22, 2018 7:32 pm

I have been getting the following error in ObjectEditor: "Load failed"

This happens when I try to re-open a .c3d file which I have just saved. After playing around a bit, I think I found the cause.
The name of the folder where my .c3d objects were contained a ".". For example, if I place a .c3d file in this folder:
C:\Temp
I can open it without error.

If the folder is named:
C:\Temp.test
Then I get the "Load failed" error.

The interesting thing is, ObjectEditor does not complain when I open an .obj file from this folder. Nor does it complain when I save a .c3d file into this folder.

This is obviously a minor bug, but it cost me a fair amount of time figuring out the cause, so I have created a support ticket.

Rene Queiroz
Posts: 101
Joined: Fri Mar 21, 2014 12:21 am

Re: ObjectEditor - Load Failed

Post by Rene Queiroz » Wed Dec 04, 2019 1:53 pm

I had the same problem! Just remove the "." on the name of the airports and everything is back to normal! :D
Image
Image

Post Reply