SketchUp Pro 2018

[finnk]

Anyone with experience in exporting obj files from SketchUp 2018?
I get an access violation from ObjectEditor.

[OXO]

Objects MUST be triangulated to import into ObjectEditor

[finnk]

I do that as well, same error.
Is there a problem using ShetchUp 2018?

[OXO]

do you have both obj and mtl files?

[tarn]

ObjectEditor doesn't like the .obj files produced by Sketchup. Some people have had success by:
1) Export .obj from Sketchup
2) Import .obj into Wings3d
3)) Export .obj from Wings3d
4) Open the new .obj in ObjectEditor

This thread may help:
viewtopic.php?f=38&t=17727&p=153825&hil ... up#p153825

[finnk]

Thanks, will try that.

[zejdla]

Same problem with Rhino3D ..... created files must be imported into Wings and re-saved ..... works good, but its little bit uncomfortable ...
3DStudo works very good without problems ....

[OXO]

If only one of you would reply to my questions, or upload the problem files on a support ticket, I could get these things fixed...

[finnk]

Done - I've send a support ticket.