Hi all,
I have just started attempting to build a new scenery for my local area here in QLD.
I have been following the instructions as set out in the condor landscape guide.
however when i get to the landscape editor, the image that comes up looks like (pic 2).. Now im assuming there is an issue in my process between the QGIS - rawtotrn - landscape editor stages as the image (pic 1) coming from QGIS looks fine.
Does anyone have any experience with this kind of issue?
building a new scenery
building a new scenery
You do not have the required permissions to view the files attached to this post.
- EDB
- Posts: 1575
- Joined: Mon Oct 31, 2011 1:17 am
- Location: The Netherlands, Europe Continent, Earth Planet, Milky Way Galaxy, Virgo Super Cluster
Re: building a new scenery
Never seen it. What I do see is, that your source area is too small or your target area is too big...
- Jan Oorthuijsen
- Posts: 491
- Joined: Sat Jul 02, 2005 4:27 pm
- Location: Utrecht (Terwijde) - Holland
Re: building a new scenery
HI Chambo,
I think that mix up the values of rows and collumns can cause this problem, it has been a few years since I have also experienced this problem. I am not sure about this but it is worth trying.
Jan (WW)
I think that mix up the values of rows and collumns can cause this problem, it has been a few years since I have also experienced this problem. I am not sure about this but it is worth trying.
Jan (WW)
PH-722
WW
It’s Difficult to Soar Like An Eagle
When You’re surrounded By Turkeys
WW
It’s Difficult to Soar Like An Eagle
When You’re surrounded By Turkeys