QGIS questions

[pstrzel]

I noticed in the Condor Landscape Guide rev1a tutorial, the QGIS clipper tool uses UTM coordinates, but mine defaults to degrees. Since using degrees causes a failure, I simply typed UTM coordinates instead. It seemed to work, but it makes the red selection area disappear. Can you point me to where I can switch units or otherwise make this right? The QGIS help menu is no help. I suspect this may be what's causing RawToTrn to give me an "Out of Memory" error, and fail to show preview of the clipped file

[arneh]

Have you reprojected (warped) the scenery? And then selected the right UTM projection you in the bottom right of the main window?

[pstrzel]

Yes, everything up to that point was good: properly merged, warped, and now I can say clipped since I was able to preview it just now, but still out of memory (edit: in RawToTrn). Disappointing

Edit: posted in the wrong thread again.