Kobo (again!)
Posted: Tue Jun 23, 2020 12:08 am
Sorry - still need advice on the Kobo and XCSoar!
I have successfully connected the KOBO using the internal RS232 TTL connections, and it works just fine using Condor and XCSoar.
However, we need to use it in our gliding simulator, which is in a totally blacked-out room, and so, of course, the KOBO screen isn't visible!
It obviously can been seen in the normal book-reading mode, by adjusting the back-light, but the back-light setting is not retained when using XCSoar.
Does anyone have a solution to setting the back-light on when using XCSoar?
I have asked in the XCSoar forum, but have not had any replies - just lots of 'reads'!
Many thanks,
Allen
I have successfully connected the KOBO using the internal RS232 TTL connections, and it works just fine using Condor and XCSoar.
However, we need to use it in our gliding simulator, which is in a totally blacked-out room, and so, of course, the KOBO screen isn't visible!
It obviously can been seen in the normal book-reading mode, by adjusting the back-light, but the back-light setting is not retained when using XCSoar.
Does anyone have a solution to setting the back-light on when using XCSoar?
I have asked in the XCSoar forum, but have not had any replies - just lots of 'reads'!
Many thanks,
Allen