Set up for Thrustmaster T.16000M and CH Pro Pedals

[evergreen]

Hi,

I am new to Condor and am looking for detailed set up settings for the Thrustmaster T.16000M FCS and CH Pro Rudder Pedals. I have everything working but am looking for the optimum specific settings for 1) non-linearity 2) ratio 3 ) stick force simulation 4) pedals force simulation.

Also, should I have the 1) stick trim where available box checked 2) stick centers with hand off box checked 3) force feedback box checked?

Thanks in advance for the advice. Feel free to reply via email as well.

Steve

[mbamberg]

Steve, check your private mail on this forum.

Mike

[Oldsoar]

I also have a Thurstmaster T.1600M .
Do you have any suggestions on setting up the rudder?
It is currently oversensitive: giving full deflection with only slight pedal movement.

[evergreen]

For my rudder pedals I have non-linearity about 1/3 of the way to the right, ratio 50% and pedal force simulation all the way left. I would recommend experimenting with different settings to see what you like best.

[emccarthy556]

I have purchased just the Thrustmaster T16000M joystick, and I was wondering how you got it to work ?
I have the main joystick part working and the slider behind the stick, but the input setup in condor does not see any of the other buttons or provide feedback.
I have windows 11.
Using the TARGET utility I got some of the buttons mapped to keystrokes, but then the joystick part did not work.