With good morning everyone:
I am Max "Lento" from Turin, Italy
Long time use Condor 1 with Panel Builder, regular licenses.
I use 1 PC and two monitors in my home cockpit and have never had a problem.
Now I have installed Condor2 in the some computer (no uninstall Condor1) and after checking its UDP.ini file and correct settings and exact port values Panel Buider loads the gauges but starting the flight they don't work.
>Does it depend on the fact that in Condor 2 the UDP.ini file is placed in the "Setting" folder while in Condor 1 it was simply the main folder and therefore does not see it well?
>Is it possible to move it from the "setting" folder or duplicate it main?
Many thanks for the replies
Max
Condor2 with Panel Builder: problem
Condor2 with Panel Builder: problem
You do not have the required permissions to view the files attached to this post.
Re: Condor2 with Panel Builder: problem
Quite plausible, but I can't verify this
Yes, you can duplicate it as it is a static file.>Is it possible to move it from the "setting" folder or duplicate it main?
Just be sure to update it if you modify the original
CN: MPT — CondorUTill webpage: https://condorutill.fr/
Re: Condor2 with Panel Builder: problem
If you're talking about Simplugins from BajuSoftware
I've had this since Condor 1 that I uninstalled.
Condor 2 is installed alone
Without touching the location of UDP.ini.
And it works very well too on a second screen.
I didn't touch the port configuration either.
I'm using CoTaSa with redirection and it has never been a problem.
Let's hope it's this plug-in.
I've had this since Condor 1 that I uninstalled.
Condor 2 is installed alone
Without touching the location of UDP.ini.
And it works very well too on a second screen.
I didn't touch the port configuration either.
I'm using CoTaSa with redirection and it has never been a problem.
Let's hope it's this plug-in.